J-Trims
J-Trims are used to finish the terminal end of tiles when not adjoined to anything. To install, first keep the adhesive a few inches from the tile's edge whtere you intend to use the J-Trim. This will allow the trim to slide into place. Dispense a bead of sealant into the receiving channel of the trim and then press the trim into place.
Inside Corner Trim
Inside Corner Trims should be attached with adhesive to the substrate. Dispense a small bead of adhesive directly to the substrate corner or on the trim itself. Also dispense a bead of sealant into each of the trim's channels to prevent water from reaching the substrate.
L-Trims
L-Trims are used to cover existing exposed tiles to provide a finished look. Install by dispensing a thin bead of sealant on the Palisade panel side and a thin bead of adhesive on the substrate side. Press trim into place. If trim will not stay in place, use some masking tape or painter's tape to hold until adhesive sets.
